Drive STINGRAY Operator's Manual download pdf (Page 39)

Host Interface

5 - 1

SECTION FIVE: HOST INTERFACE

In this section:

• Host command quick reference (this page)

• Message considerations (p. 5-2)

• Commands and queries (p. 5-5)

• SCPI error codes (p. 5-10)

When a command is sent to the Coherent StingRay laser, the

parameter for the command is stored in internal persistent

memory, which has a logic cell life of 10 thousand cycles. The cell

life sets the limits for repetitive commands sent to the Coherent

StingRay laser.

This only applies to commands and not queries.

Host Command

Quick

Reference

The following table gives a brief description of all host commands

and queries. For detailed information about a specific command or

query, go to the page referenced in the right-hand column.

Table 5-1. Host Command Quick Reference (Sheet 1 of 2)

Command Description

Page

No.

*IDN? Device ID query 5-5

SYST:CDRH Enables/disables 5-second CDRH delay 5-5

SYST:CDRH? Queries CDRH delay state 5-5

SYST:COMM:BAUD Sets serial communication baud rate 5-6

SYST:COMM:BAUD? Queries serial communication baud rate 5-6

SYST:COMM:HAND Enables/disables SCPI handshaking 5-6

SYST:COMM:HAND? Queries SCPI handshaking state 5-6

SYST:COMM:PROM Enables/disables interactive prompt 5-6

SYST:COMM:PROM? Queries interactive prompt state 5-6

SYST:DIOD:HOUR? Queries laser diode usage hours 5-6

SYST:FAUL? Queries system fault 5-6

SYST:INF:CDAT? Queries factory calibration date 5-7

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 57 58

No comments

Drive STINGRAY Operator's Manual Page 39